peugeot 407 key fob 308 Key Fob Replacement

Peugeot's 308 may be slightly old but it's appealing. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful driving experience.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent the following suggestions should assist.

Water Damage

If you accidentally drop your key fob in a puddle or splash it with water when kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to sustain water damage. The best way to avoid this from happening is to keep it in a dry bag whenever you're out in the open or engaging in things where the fob might be exposed to a lot of water.

You'll also want to ensure that the fob is completely dry before opening it up and using it again. If you detect any smells coming from the fob, like an industrial-like liquid smell or the scent of windshield washer fluid, this is another indication that it's been submerged in water.

A wet circuit could cause the battery's power to be depleted or even explode. If you can remove your keyfob 308 out of the water and turn it upside up and shake as much water out as you can prior to opening the casing. Take the battery out, and then wipe the circuit board clean using a cotton swab that is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issue signal interference or a malfunctioning chip. If none of these causes the cause, you can try resetting the system by disconnection of the battery at 12 volts for around 15 minutes.

Dead Coin Battery

peugeot spare Key cost cars come with remote start systems that allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car before they enter. This feature is extremely beneficial particularly during the winter's cold and chilly months. The remote start system can stop working for a variety reasons, such as a dead coin-battery.

A coin-shaped battery that is located inside the key fob has a life span of two to four years, depending on how often it is used and the location where it was purchased. The date of use is typically printed on the packaging or listed in the instruction manual.

If the key fob has stopped working after exposure to clean tapwater, remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob was exposed to salty or soapy water, it could have fried the chip. You will need to replace it.

If you're not certain the battery is in good condition you can check its voltage using a multimeter set to your car's voltage range and connected to the plus and minus terminals. The voltage should be around 12-13 volts but if it is lower, the battery must be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.

Faulty Receiver Module

If you don't see "Key Detected" It could be the receiver module faulty. It's the part that sends an alert to the car when your key fob is activated, that also acts as an immobiliser. It also stops it from starting until the correct key is present.

The cause could be many reasons, such as water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob has been damaged due to dirty tap water it could be because the keyfob was exposed it. In this case you will have to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the issue continues to persist, it is a good idea that you visit the local Peugeot expert or locksmith. They can utilize an instrument for diagnosing to pinpoint the issue and repair it.

Losing your Peugeot car keys could be a stressful experience. However, a trained auto locksmith can address the problem in minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a local locksmith near you.

Faulty electronic chip

The electronic chip that is in the Peugeot 308 key fob plays an essential part in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message that says "anti-theft". In this instance, the only solution is to replace the key. Luckily, professional auto locksmiths are able to provide this service within the shortest period of time.

The chip in your peugeot key fob 308's key fob may fail due to different reasons, such as sweat, water damage, or dirt. If your peugeot key repair 308 key fob is exposed to soapy water, you must clean it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. The battery must then be allowed to completely dry.

Radio interference can cause a key fob to stop functioning. This could be caused by other devices operating at the same frequency as your peugeot 206 new key key fob. It could also be caused by bad weather or objects in the vicinity. It is recommended that you visit a Peugeot dealer if you have this problem.

The peugeot 208 replacement key Key Fob 207/308 is very delicate and requires particular care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.